Skip to content

Breakout Boards

Filters

  • £15.48 inc VAT
    £12.90 - £12.90
    £12.90
    £12.90 - £12.90
    £12.90
    ex VAT

    ATMEGA8U2 Breakout

    sku: DEV-10277 The board comes pre-loaded with the SparkFun USB to Serial COM Port firmware. When the board plugs into a USB port, Windows will as...

    View full details
    £15.48 inc VAT
    £12.90 - £12.90
    £12.90
    £12.90 - £12.90
    £12.90
    ex VAT
  • £23.88 inc VAT
    £19.90 - £19.90
    £19.90
    £19.90 - £19.90
    £19.90
    ex VAT

    Energy Harvester - LTC3588 Breakout

    sku: BOB-09946 This breakout board uses the LTC3588 Piezoelectric Energy Harvester from Linear Technologies. This board can be used not only for h...

    View full details
    £23.88 inc VAT
    £19.90 - £19.90
    £19.90
    £19.90 - £19.90
    £19.90
    ex VAT
  • £8.28 inc VAT
    £6.90 - £6.90
    £6.90
    £6.90 - £6.90
    £6.90
    ex VAT

    Breakout Board for SD-MMC Cards

    sku: BOB-00204 With SD and MMC memory prices dropping, the time is right for mass storage and datalogging. This breakout board will allow you to b...

    View full details
    £8.28 inc VAT
    £6.90 - £6.90
    £6.90
    £6.90 - £6.90
    £6.90
    ex VAT
  • Sold out
    £10.92 inc VAT
    £9.10 - £9.10
    £9.10
    £9.10 - £9.10
    £9.10
    ex VAT

    PCM1803A Analog to Digital Stereo Converter Breakout

    sku: BOB-09365 The PCM1803A is a high-performance, low-cost, 24-bit stereo analog-to-digital converter that can sample as high as 96k. The PCM1803...

    View full details
    £10.92 inc VAT
    £9.10 - £9.10
    £9.10
    £9.10 - £9.10
    £9.10
    ex VAT
    Sold out
  • £5.04 inc VAT
    £4.20 - £4.20
    £4.20
    £4.20 - £4.20
    £4.20
    ex VAT

    Opto-isolator Breakout

    sku: BOB-09118 This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a ...

    View full details
    £5.04 inc VAT
    £4.20 - £4.20
    £4.20
    £4.20 - £4.20
    £4.20
    ex VAT
  • £1.56 inc VAT
    £1.30 - £1.30
    £1.30
    £1.30 - £1.30
    £1.30
    ex VAT

    RJ45 Ethernet MagJack Breakout

    If you need to get your MagJack into a breadboard, this is for you. This board exposes all pins, LEDs, and housing with breadboard friendly spacing...

    View full details
    £1.56 inc VAT
    £1.30 - £1.30
    £1.30
    £1.30 - £1.30
    £1.30
    ex VAT
  • Sold out
    £4.08 inc VAT
    £3.40 - £3.40
    £3.40
    £3.40 - £3.40
    £3.40
    ex VAT

    OpAmp Breakout

    This is a simple Op Amp breakout board, set up as a 2-stage amplifier with a gain of 100 (gain of 10 for each stage). The on-board trim pot sets th...

    View full details
    £4.08 inc VAT
    £3.40 - £3.40
    £3.40
    £3.40 - £3.40
    £3.40
    ex VAT
    Sold out
  • £1.56 inc VAT
    £1.30 - £1.30
    £1.30
    £1.30 - £1.30
    £1.30
    ex VAT

    Breakout Board for RJ45

    This is a small PCB that brings out the pins of the RJ45 connector to an in-line 0.1" footprint. Use with break-away headers for breakboarding or c...

    View full details
    £1.56 inc VAT
    £1.30 - £1.30
    £1.30
    £1.30 - £1.30
    £1.30
    ex VAT
  • £8.28 inc VAT
    £6.90 - £6.90
    £6.90
    £6.90 - £6.90
    £6.90
    ex VAT

    Breakout Board for microSD Transflash

    Breakout board for the microSD socket that is not much bigger than your fingernail. Compatible with the SPI interface found on any SD card, this ti...

    View full details
    £8.28 inc VAT
    £6.90 - £6.90
    £6.90
    £6.90 - £6.90
    £6.90
    ex VAT
  • £24.12 inc VAT
    £20.10 - £20.10
    £20.10
    £20.10 - £20.10
    £20.10
    ex VAT

    DC-DC Converter Breakout

    This is a breakout board for our non-isolated, 6A DC-to-DC Converter Module. The module can convert any DC voltage between 4.5-14VDC to a selectabl...

    View full details
    £24.12 inc VAT
    £20.10 - £20.10
    £20.10
    £20.10 - £20.10
    £20.10
    ex VAT
  • £5.04 inc VAT
    £4.20 - £4.20
    £4.20
    £4.20 - £4.20
    £4.20
    ex VAT

    NCP1400-5V Step-Up Breakout

    The NCP1400 is a 5V DC-DC converter. The breakout board will accept voltage inputs between 1 and 4 Volts and output a constant, low ripple 5V outpu...

    View full details
    £5.04 inc VAT
    £4.20 - £4.20
    £4.20
    £4.20 - £4.20
    £4.20
    ex VAT
  • £4.92 inc VAT
    £4.10 - £4.10
    £4.10
    £4.10 - £4.10
    £4.10
    ex VAT

    NCP1400-3.3V Step-Up Breakout

    The NCP1400 is a 3.3V DC-DC converter. The breakout board will accept voltage inputs between 1 and 3 Volts (such as 1 or 2 AA batteries) and output...

    View full details
    £4.92 inc VAT
    £4.10 - £4.10
    £4.10
    £4.10 - £4.10
    £4.10
    ex VAT