ESP32S3 CAN and LIN-Bus board

This board has an ESP32-S3-WROOM-1-N8R8 module with Bluetooth, Wifi and a CAN transceiver. LIN-bus is provide by a TJA1021T LIN transceiver.  On board is a RGB LED, boot and reset button. Programming is done via USB C.

• ESP32-S3 series of SoCs embedded, Xtensa® dual-core 32-bit LX7 microprocessor (with single precision FPU), up to 240 MHz
• 8MB Quad SPI flash
• 8MB PSRAM
• Bluetooth LE, Bluetooth 5 and Bluetooth mesh 
• Wifi 802.11b/g/n
• On-board PCB antenna
• Programming via USB-C connector
• Boot and Reset push button
• CAN transceiver
• TJA1021T LIN transceiver
• I2C connector for sensors
• Supply voltage : 7v to 14v SMPS module with reverse polarity protection
• RGB LED

Documents

• Schematic
• CAN and LIN-bus NCV7430 RGB LED demo
• LIN window switch read demo

Ensure to select Board:ESP32S3 Dev Module, USB CDC On Boot: "Enabled", PSRAM: "OPI PSRAM", Upload Mode: "USB-TG CDC (Tiny USB)".